5 Product Support and Maintenance
5.1 Maintenance and Service
Do not use alcoholic cleaning agents.
The SSA-EB1PLx-0Dx is maintenance-free.
For long-term and trouble-free operation, please periodically check the following points:
• solid fit of all components
• reliable switching function
• if damage occurs, please exchange the relevant components
Liability disclaimer— By breach of the given instructions (concerning the intended use, the safety instructions, the
installation and connection through qualified personnel and the testing of the safety function) manufacturer’s liability
expires.
5.2 Status Indicators
Operating Mode
OSSD Inputs
Indication
OSSD Outputs
Power-up
X
Armed color (yellow, green or off, depending on the model) on for
0.5 s
Red on for 0.5 s
Off for 0.5 s minimum
OFF
Armed (button not pressed)
ON
Yellow, green, or off (depending on the model)
ON
Actuated (button pressed)
X
Flashing red
OFF
Re-armed, reset needed (specific models)
ON
Red
OFF
Armed
OFF
Armed indication (yellow, green or off, depending on the model)
OFF
Fault detected (non-critical)
X
Double flash red
ON
Fault detected (critical)
X
Double flash red
OFF
Faults that do not immediately compromise the safe operation of the emergency stop device (for example safety output to
external potential, crosswire short safety output) result in a delayed switch-off of the OSSDs. The OSSDs will turn off when
the error warning exceeds 20 minutes. See
on p. 7 for more details.
5.3 EU Declaration of Conformity (DoC)
Banner Engineering Corp. herewith declares that these products are in conformity with the provisions of the listed directives
and all essential health and safety requirements have been met. For the complete DoC, please go to
.
Product
Directive
SSA-EB1PLx-0Dx Series Lighted Emergency Stop Button
with ISD
Machinery Directive 2006/42/EC
Representative in EU: Peter Mertens, Managing Director, Banner Engineering BV. Address: Park Lane, Culliganlaan 2F, bus
3,1831 Diegem, Belgium.
5.4 Information Available Using ISD
Obtain the following information from the ISD chain and a diagnostic unit or an ISD-enabled Safety Controller.
Cyclic Data about the Chain
Short Name
Data Format
Description
Count mismatch
1/0
The number of devices in chain does not match configuration
SSA-EB1PLx-0Dx Series Lighted Emergency Stop Button with ISD
18
www.bannerengineering.com - Tel: + 1 888 373 6767
