Original Instructions
July 07, 2023
p/n: 226574 Rev. B
226574
R70ER Ethernet Data Radio
•
•
•
•
•
•
R70ER Features
The
Sure Cross R70ER Ethernet Data Radio
is a compact, industrial, communication device used to create point-to-multipoint configurations
of wireless Ethernet networks. The
R70ER
is available in two frequencies, 900 MHz and 2.4 GHz, and is fitted with D-Code M12 quick
disconnect connectors for fast deployment.
Star or tree network topology configuration
DIP switches select operational modes
No IP address configuration is required
Frequency Hopping Spread Spectrum (FHSS) technology ensures reliable data delivery
Self-healing, auto-routing radio frequency network with multiple hops to extend the network's
range
Advanced Encryption Standard (AES) using a 256-bit cryptographic key
For additional information, updated documentation, and a list of accessories, refer to Banner Engineering's
.
Models
Models
Frequency
Transmit Power
R70ER9MQ
900 MHz ISM Band
500 mW
R70ER2MQ
2.4 GHz ISM Band
65 mW (100 mW EIRP)
Quick Start Guide
Set Up Your R70ER Radio Network
Each radio network should include one controller/primary radio and several repeater or peripheral radios. To set up and install your wireless
data radio network, follow these steps:
Before installing your Ethernet data radios, first verify that your Ethernet devices work.
This verifies the devices are configured correctly before replacing the cabled connection with a wireless connection.
1.
Connect your devices using an Ethernet cable.
a.
Configure the IP addresses of your devices and use a ping test with Ethernet cables to verify the connectivity before
installing the radios.
b.
Configure the DIP switches of the R70ER.
2.
Apply power to all devices.
3.
Form the wireless network by binding the repeater and peripheral radios to the controller/primary radio.
4.
Observe the LED behavior to verify the devices are communicating with each other.
5.
Verify the Ethernet devices work wirelessly.
6.
Remove power to the R70 devices.
a.
Connect your Ethernet devices to the R70 Ethernet Radios and apply power.
b.
Run a ping test to confirm data is moving correctly through the wireless network.
c.
© Banner Engineering Corp.
