4 Banner Radar Configuration Workspace
4.1 Navigation Toolbar
Use this toolbar to connect to the sensor, to save or load a configuration, or to reset to factory defaults.
From the
File
menu, the following options are available:
Load Config
Load a configuration to the connected sensor. Use this option to set up multiple sensors with the same parameters.
Save Config
Save a configuration to a desired location for future use.
Reset Frequently Used Settings
Resets the software settings without changing the configuration of the attached sensor.
Exit
Exit the Banner Radar Configuration Software.
From the
Sensor
menu, the following options are available:
Connect
Connect to the sensor.
Disconnect
Disconnect from the sensor.
Factory Reset
Select to perform a factor reset on the sensor. All custom parameters will be lost.
From the
Help
menu, the following option is available:
About
Select to view the software version number, the copyright notice, and the warranty.
4.2 Live Sensor Data and Legend
The Live Sensor Data area displays the live distance and amplitude signal from the connected radar sensor. The signal
strength threshold, switch point, and hysteresis are also plotted. Use these signals to evaluate targets to determine where the
signal strength threshold and switch point should be configured for reliable detection.
Use the
Y-Axis Max
and the
X-Axis Max
to adjust the range displayed on the plot.
Legend
Use the legend to select which data appears on the graph.
Signal Threshold
Displays the signal strength threshold.
Primary Target
Represents the signal strength and location of the nearest target inside the switch point.
Discrete 1/2 Window
1
The range for the discrete output.
Switch Point Lines
Displays the switch point distance.
Hysteresis Lines
Displays the hysteresis distance.
1
Varies by output model.
R-GAGE
®
K50R Radar Sensor
8
www.bannerengineering.com - Tel: + 1 888 373 6767
