Note:
If a factory reset is performed through the Banner Radar Configuration Software, the remote input
wire becomes disabled (factory default setting). If the sensor is returned to factory defaults by using the
remote input wire, the input wire remains enabled and the rest of the settings are restored to factory
defaults.
5.2.1 Remote Teach
Use the following procedure to teach the first and second switch points.
Note:
If Indication is disabled from the Banner Radar Configuration Software or a Pro model is being used,
no LEDs are active during the following procedure.
1. Pulse the remote input once.
The Power/Signal LED flashes green rapidly and both amber LEDs are off.
2. Present the first point.
3. Teach the switch point.
Action
Result
Single-pulse the remote input.
T
Teach Accepted
The amber LED of the output being taught
flashes while the amber LED of the output
not being taught is off. The Power/Signal
LED indicates signal strength.
Teach Not Accepted
The Power/Signal LED continues to flash
green and the amber output LED is off.
Retry teaching the first point.
4. Present the second point.
5. Teach the switch point.
Action
Result
Single-pulse the remote input.
T
Teach Accepted
The Power/Signal LED turns on.
The sensor returns to run mode.
Teach Not Accepted
The Power/Signal LED continues to indicate
signal strength, the amber LED of the output
being taught continues to flash while the
amber LED of the output not being taught is
off.
Retry teaching the second point.
5.2.2 Remote Setup
Use Remote Setup to set the output mode to normally open or normally closed, or to set the teach mode.
Changing the output to normally open or normally closed takes effect immediately and does not alter the switch point
distance. Changing Teach mode does not immediately change the switch point location, but will affect the behavior of the
next remote Teach.
Discrete Teach Modes
Teaching two separate points creates a window around that range.
Background Teach—Teaching the same point twice (points within 100 mm of each other) sets the switch point 200 mm in
front of the taught point.
Object Teach—Teaching the same point twice (points within 100 mm of each other) sets the switch point 100 mm behind the
taught point.
Window Teach—Teaching the same point twice (points within 100 mm of each other) sets a window ±50 mm on either side
of the taught point, for a total window size of 100 mm.
R-GAGE
®
K50R Radar Sensor
14
www.bannerengineering.com - Tel: + 1 888 373 6767
