Banner Q3XTBLD150-Q8, Инструкция по эксплуатации

Страница: 18 / 31

Table 5: Expected TEACH Behavior for Window Set
Condition TEACH Result Display
A valid condition is detected. Sets a symmetric window around the
taught condition. The threshold window is
set by the value.
The current NSS displays.
The taught condition is at a valid low signal
level.
Sets a symmetric window around the
taught condition, using the minimum offset
value.
The achieved percent briefly displays, and
then the current NSS displays.
The taught condition is less than the
minimum detection range.
Sets a single threshold at the minimum
level. Sets the sensor at the maximum
detection condition.
briefly displays, and then the current
NSS displays.
The taught condition plus the offset is
greater than the detection range.
Sets a single threshold at the maximum
level. Sets the sensor at the minimum
detection condition.
briefly displays, and then the current
NSS displays.
3.5.5 Light Set
Light set sets a switching threshold a user-selectable percent offset below the presented condition. Use the menu to set the
offset percentage. The default is 20%.
Output OFF
Darkest
(no signal)
Most Light
(saturated
signal)
Output ON
Condition
Presented
Threshold position
adjusted by
Manual Adjust
Sensor positions the
threshold slightly below
the presented condition
Figure 11. Light Set (Light Operate shown)
Note: The sensor must be set to = to use the following instructions.
Note: To program the sensor using remote input, remote input must be enabled ( = )
1. Present the target.
Method Action Result
Push Button
Present the target. The sensor-to-target distance must be within the sensor's
range.
The target's value displays.
Remote Input
2. Start the TEACH mode.
Method Action Result
Push Button Press and hold TEACH for longer than 2 seconds.
and flash alternately on
the display. The DYN and WND indicators
flash.
Remote Input No action required. n/a
3. Teach the sensor.
Q3X Laser Contrast Sensor
18 www.bannerengineering.com - Tel: 763.544.3164