Banner Q3XTBLD150-Q8, Инструкция по эксплуатации

Страница: 17 / 31

Table 4: Expected TEACH Behavior for Dynamic TEACH
Condition TEACH Result Display
At least one taught condition is between
the minimum and maximum signal level
limits.
Sets the threshold between the two
conditions.
The current NSS displays.
All conditions are darker than the
minimum signal value limit.
Sets the threshold at the minimum level.
Sets the sensor at the maximum detection
condition.
briefly displays, and then the current
NSS displays.
All conditions are brighter than the
maximum signal value limit.
Sets the threshold at the maximum level.
Sets the sensor at the minimum detection
condition.
briefly displays, and then the current
NSS displays.
All conditions are at the same signal level.
This is a Calibration Set.
Sets the threshold slightly below the two
taught conditions.
briefly displays, and then the current
NSS displays.
3.5.4 Window Set
Window set sets a sensing window using the window offset percentage. Use the menu to set the window offset percentage. The
default is 20%.
Darkest
(no signal)
Most Light
(saturated
signal)
Single
taught
point
Sensing window size
adjusted by
Manual Adjust
Output OFF Output OFF Output ON
Figure 10. Window Set (Light Operate shown)
Note: The sensor must be set to = to use the following instructions.
Note: To program the sensor using remote input, remote input must be enabled ( = )
1. Present the target.
Method Action Result
Push Button
Present the target. The sensor-to-target distance must be within the sensor's
range.
The target's value displays.
Remote Input
2. Start the TEACH mode.
Method Action Result
Push Button Press and hold TEACH for longer than 2 seconds.
and flash alternately on
the display. The WND indicator flashes.
Remote Input No action required. n/a
3. Teach the sensor.
Method Action Result
Push Button Press TEACH to teach the target.
The sensor sets the window and returns
to Run mode.
Remote Input Single-pulse the remote input.
T
flashes briefly on the display
and the sensor returns to Run mode.
Q3X Laser Contrast Sensor
www.bannerengineering.com - Tel: 763.544.3164 17