Banner DXMR90-X1 Series, Инструкция по эксплуатации

Страница: 42 / 55

May 09, 2023
DXMR90-X1 Series Controller Instruction Manual
42
If the DXM GSD file does not install properly, save the log and contact Banner Engineering Corp.
Change the Device IP Address
Follow these instructions to change the IP address of the DXM device using the Siemens TIA Portal (v14) software. Use
these instructions as a basis if you are using another controller (PLC).
The system installs the DXM GSD file and places it in the Hardware catalog . In the example, the DXM GSD file is lo-
cated under Other field devices › PROFINET IO › Banner Engineering Corp. › Banner .
Launch the Siemens TIA Portal (v14) software.
1.
Click Open existing project .
2.
Select a project and open it. 3.
Click Devices & networks .
Network view
The Network view displays.
4.
Double-click on the DXM icon to open the Device view screen.
5.
Click on the DXM icon in the graphic area of the Device view screen.
The Module properties window displays and the module can now be configured.
6.
Click Properties .
7.
Click General .
8.
Select PROFINET Interface › Ethernet addresses .
Ethernet addresses
9.
Select Set IP address in the project .
10.
Enter the IP address.
11.
Right-click on the device icon and select Online & diagnostics .
12.
© Banner Engineering Corp.