2
Installation
Instructions
2.1
Mounting
Instructions
Mount on a DIN Rail
1. Hook the DIN rail clip on the
bottom
of the DF-G2 over
the edge of the DIN rail (1).
2. Push the DF-G2 up on the DIN rail (1).
3. Pivot the DF-G2 onto the DIN rail, pressing
until
it snaps
into place (2).
Mount to the Accessory Bracket (SA-DIN-BRACKET)
1.
Position
the DF-G2 in the SA-DIN-BRACKET.
2. Insert the supplied M3 screws.
3. Tighten the screws.
Remove from a DIN rail
1. Push the DF-G2 up on the DIN rail (1).
2. Pivot the DF-G2 away from the DIN rail and remove it (2).
2.2 Installing the Fibers
Follow these steps to install glass or
plastic
fibers.
1. Open the dust cover.
2. Move the
fiber
clamp forward to unlock it.
3. Insert the
fiber(s)
into the
fiber
port(s)
until
they stop.
4. Move the
fiber
clamp backward to lock the
fiber(s).
5. Close the dust cover.
Fiber Emitter
Port
Fiber Receiver
Fiber Clamp
Port
Move forward
to release the
fibers
Note: For
optimum
performance of IR models, if applicable, glass
fibers
must be used.
DF-G2 High Speed Expert Dual Display Fiber
Amplifier
with Dual Discrete Outputs and IO Link
www.bannerengineering.com - Tel: 763.544.3164
5
