Bang & Olufsen BeoSound Moment, Руководство по установке

Страница: 14 / 70

LED indications 14
LED indications
Wireless Speaker LED indications
State Signal Time Comment
Standby Off - Product is in standby mode
Normal operation Off - Normal operation and no speakers are connected wirelessly
Normal operation White
(solid)
Off after 10 s time-out Speakers are connected wirelessly
Speaker connections behave normally.
Scanning (associating) Green (fast flas hing) 100 ms/100 ms
no time-out
In setup mode and open for associating with (scanning for) speakers
Leaving scan mode (associating) Green ( slow flashing) 200 ms/200 ms
until speaker are setup
Speakers are associated with (found) but not set up yet
Wireless Power Link strength low Orange (solid) no time-out The general Wireless Power Link connection quality is low
Wireless Power Link failure Orange (fast flashing) 100 ms/100 ms
no time-out
Wireless Power Link network failure
Network LED indications
State Signal Time Comment
Network module is booting White (slow flashing) 200 ms/200 ms Booting BeoSound Moment hub (SoundHeart)
Network connected White (solid) - Wired or wireless network connection is established and signal strength is strong
Network not connected Orange ( slow flashing) 200 ms/200 ms
no time-out
Wired or wireless network connection is not established
Critical firmware problem Red
( slow flashing)
200 ms/100 ms
no time-out
Critical firmware problem. Disconnect product from mains and reconnect. If problem
persists, start fault finding
SoftAP mode (initiated automatically
or manually). See page 51 .
Green
(slow flas hing)
200 ms/100 ms Product in setup mode
Product Status LED indications (Power LED)
State Signal Time Comment
Turning to
Standby mode
Red (solid)
5 s then
Green (solid)
- Product is in standby mode, and silent.
Occur according to Power Saving settings, after 2 and up to 30 minutes when not playing,
or set to Standby by remote control
Power On Green (flashing) until
started up
- Product is being powered On and starting up
Normal operation Green (solid) - Sound is heard from speakers
Software update Red
(flashing)
100 ms/100 ms
min 1 s then Off
When update is completed the product automatically restarts. During update do not operate
or switch Off the product
Remote control command received Green (solid) off for 100 ms Product receives a remote control command
Mute LED indications
State Signal Time Comment
Mute On (active) Green
(solid)
- The Mute toggle function is On; music signal is turned off in the entire product
Note: This mode differs to the Play/Pause function chosen by the function wheel
Mute Off (deactive) - - The Mute toggle function is Off