B&R Power Panel C50, Руководство пользователя

Страница: 30 / 76

Device description
30 Power Panel C50 User's manual V1.10
4.8 Operating and connection elements
1
2
3 4 5 6 7
8
9
10
1 Reset button
2 Diagnostic LED status indicators
3 Grounding clip
4 Power supply
5 IF3: USB interface
6 IF4: USB interface
7 IF1: POWERLINK interface
8 IF2: Ethernet interface
9 OP1/OP2: Fieldbus interfaces (depending on the Power Panel variant)
10 IF5: X2X Link interface
4.8.1 Diagnostic LED status indicators
The following diagnostic LEDs are located on the back of the Power Panel C50:
Figure LED Color Status Description
On Application running.
Double flash Mode BOOT (during firmware update)
Green
Blinking Mode BOOT (system startup)
On Mode SERVICE or overtemperature shutdown
R/E
Red
Blinking If LED "R/E" blinks red and LED "RDY/F" blinks yellow, a license violation has
occurred.
On Mode SERVICE or BOOT. RDY/F Yellow
Blinking If LED "R/E" blinks red and LED "RDY/F" blinks yellow, a license violation has
occurred.
S/E Green/
Red
LED "Status/Error" for the POWERLINK interface.
For a description, see section "LED "S/E" (LED "Status/Error")" on page 31 .
OPS1
OPS2
OPS3
OPS4
OPS5
RES
R/E
RDY/F
S/E
OPS1
OPS2
OPS3
OPS4
OPS5
These LEDS have a different meaning depending on the Power Panel variant.
See the description in the following sections:
• "OPS" LEDs - Variant without fieldbus interfaces
•
"OPS" LEDs - Variant with 2x CAN bus
•
"OPS" LEDs - Variant with 1x CAN bus and 1x RS232
•
"OPS" LEDs - Variant with 1x CAN bus and 1x RS485