Maintenance and service • Installing the side cover
358
Panel PC 800 User's Manual V1.30
13 Installing the side cover
The side cover can be easily removed by loosening the Torx (T10) screws. The number of Torx screws can vary
depending on the system.
13.1 PPC800 without expansion
1. Disconnect the power supply to the Panel PC 800.
2. Touch the housing or ground connection in order to discharge any electrostatic charge from your body.
3. Loosen the indicated combi-Torx screws (T10).
4. After the screws have been removed, the side cover can be removed by sliding it away from the heat sink.
Figure 222: Installing the side cover on a PPC800 without an expansion
13.2 PPC800 with an expansion
1. Disconnect the power supply to the Panel PC 800.
2. Touch the housing or ground connection in order to discharge any electrostatic charge from your body.
3. Loosen the indicated combi-Torx screws (T10).
4. After the screws have been removed, the side cover can be removed by sliding it away from the heat sink.
Figure 223: Installing the side cover on a PPC800 with an expansion (1-slot expansion shown in image)