Maintenance and service • Installing and replacing slide-in drives
Chapter 7
Maintenance and service
Panel PC 800 User's Manual V1.30
345
5 Installing and replacing slide-in drives
Slide-in drives can be installed and replaced in system units with 1 card slot or in expansions with 2 card slots.
5.1 Procedure
1. Disconnect the power supply to the B&R Industrial PC.
2. Touch the housing or ground connection in order to discharge any electrostatic charge from your body.
3. Remove the dummy slide-in module or slide-in drive by unscrewing the two quick release screws.
Figure 198: Loosening the quick release screws
4. Insert the slide-in drive and tighten with the two ¼ turn screws.
Figure 199: Installing the slide-in drive