Software • BIOS options
194
Panel PC 800 User's Manual V1.30
1.4.3 Graphics configuration
Advanced
Graphics Configuration
Select primary video
adapter to be used
during boot up.
Internal Graphics Mode Select [Enabled, 8MB]
DVMT Mode Select
DVMT/FIXED Memory [128MB]
Boot Display Device
Local Flat Panel Type
SDVO Port B Device [DVI]
[DVMT Mode]
[Auto]
Boot Display Preference [LFP SDVO-B SDVO-C]
[Auto]
Local Flat Panel Scaling [Expacnd Text&Graph]
Select Screen
Select Item
SDVO Port C Device [None] +- Change Option
F1 General Help
SDVO/DVI Hotplug Support [Enabled] F10 Save and Exit
Display Mode Persistence [Enabled] ESC Exit
Primary Video Device [Internal VGA]
BIOS SETUP UTILITY
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.
Figure 100: 945GME Advanced Graphics Configuration
BIOS setting
Function
Configuration options
Effect
Internal VGA
Uses the internal graphics chip on the CPU
board as the video device (monitor/panel inter-
face)
Primary video device
Option for selecting the primary display device
PCI / Int. VGA
Uses the graphics chip of a connected graphics
card as the display device
Disabled
Nothing reserved, disables the graphics con-
troller
Enabled, 1MB
Provides 1 MB main memory
Internal graphics mode se-
lect
Option for setting the amount of memory used for
the internal graphics controller
Enabled, 8MB
Provides 8 MB main memory
Fixed mode
Allocates a fixed amount of memory to the
graphics chip, which is then no longer available
to the PC
DVMT mode
Memory consumption controlled dynamically by
the DVMT graphics driver. Only the amount of
memory that is required is reserved.
DVMT mode select
Option for determining the DVMT mode (Dynamic
Video Memory Technology) of the DVMT graph-
ics driver
Combo mode
At least 64 MB reserved by the DVMT graphics
driver (up to 224 MB possible)
64 MB
Allows 64 MB of main memory to be used
128 MB
Allows 128 MB of main memory to be used
DVMT/FIXED memory
Option for setting the amount of memory used for
DVMT mode
Maximum DVMT
Allows the remaining available main memory to
be used
Auto
Automatic selection
CRT only
Uses only the CRT (Cathode Ray Tube) chan-
nel
SDVO only
Uses only the SDVO (Serial Digital Video Out)
channel
CRT + SDVO
Uses the CRT and SDVO channel
LFP only
Uses only the LFP (Local Flat Panel) channel
Boot display device
Determines which video channel should be en-
abled for a display device during booting
CRT + LFP
Uses the CRT and LFP channel
LFP SDVO-B SDVO-C
Local Flat Panel - Serial Digital Video B output
- Serial Video C output
LFP SDVO-C SDVO-B
Local Flat Panel - Serial Digital Video C output
- Serial Video B output
SDVO-B SDVO-C LFP
Serial Digital Video B output - Serial Digital
Video C output - Local Flat Panel
Boot display preference
This option determines the order in which the de-
vices on the connected LFP and SDVO channels
should be checked and booted.
Information:
The setting only affects the system if the
"Boot display device" option is set to
"Auto".
SDVO-C SDVO-B LFP
Serial Digital Video C output - Serial Digital
Video B output - Local Flat Panel
Local flat panel type
This option can be used to set a predefined profile
for the LVDS channel.
Auto
Automatic detection and configuration using the
EDID data
Table 149: 945GME Advanced - Graphics configuration - Configuration options