Commissioning
Mobile Panel 7200 User's manual V 1.01
43
3.6 Operating the Mobile Panel
Caution!
The following points must be observed when operating the Mobile Panel.
•
When routing or installing cables, it is important to ensure that there is no risk of people falling or tripping
or of the Mobile Panel falling to the ground due to unintentional impact on the cable (e.g. by transportation
devices rolling over it).
•
The cable used to connect the Mobile Panel is not permitted to be pinched or routed over sharp edges or
rough surfaces. This can result in damage or chafing of the cable jacket.
•
It is not permitted to operate a Mobile Panel with damaged cables.
•
When the Mobile Panel is not in use, it should be safely stowed away on the intended wall mount. If the
Mobile Panel is stored on a wall mount in the machine's danger zone, stop button functionality must be
ensured, i.e. the attachment cable must be connected.
•
It is important to ensure that the Mobile Panel is not placed on the operating side when setting it down.
This may cause mechanical damage to the control devices or trigger an unintended action.
•
The touch screen is not permitted to be operated with sharp objects such as ballpoint pens, blades, screw-
drivers, etc. These objects can result in damage to the touch screen.
•
Only one entry is permitted to be made on the touch screen or the system keys at a time. Multiple entries
can trigger unintended actions.
•
Placing objects on top of the touch screen is not permitted. The touch screen could be damaged, or unin-
tended actions could be triggered.
•
The Mobile Panel is not permitted to be placed on unstable surfaces or shelves. It could fall and become
damaged.
•
The Mobile Panel is not permitted to be placed near or directly on heat sources.
•
In order to maintain the service life and functionality of the Mobile Panel, unnecessary ingress of foreign
objects, liquids or gases should be avoided.
•
All protective coverings, housing screws, cable grommets and the device housing must be checked peri-
odically for damage.
•
The cleaning instructions for the Mobile Panel in section
complied with.
3.6.1 Touch screen calibration
The touch screen devices are pre-calibrated at the factory. This feature of-
fers great advantages especially for replacement parts since recalibration is
usually no longer required when replacing a device (identical model/type).
B&R still recommends calibration for best results and to optimally adapt the
touch screen to the needs of the user.
During the calibration procedure, the specified point must be pressed four
times in succession within a certain time.
If calibration is not carried out correctly, an error message appears.
touch the crosshair
8
Figure: Touch screen calibration
3.6.1.1 Windows 10 IoT Enterprise 2016 LTSB
Microsoft multi-touch drivers are installed on the device during installation of Windows 10 IoT Enterprise 2016
LTSB. After successful installation of Windows 10 IoT Enterprise 2016 LTSB, the device is immediately ready for
operation.
