Commissioning
Mobile Panel 7200 User's manual V 1.01
41
3.5 Installing the handle and hand strap
This section describes how to install the handle and hand strap.
To install the handle and hand strap, the MP7200 must be placed with the display facing downwards. The surface
used for this must therefore be flat, clean and as soft as possible to avoid damaging the device.
Caution!
Before assembly, installation and maintenance work, the supply voltage and any interface cables must
be disconnected.
Necessary support and tools
•
Torx 10 screwdriver
If the hand strap is not required, only assembly steps 1 to 3 and 7 described below are necessary.
1. Switch off the supply voltage.
2. Disassemble the handheld control device.
3. Place the handheld control device with the display facing downwards on a suitable surface or base.
4. Feed the non-welded end of the hand strap belt (1b) through the right opening on the handle (2a). The hook-
and-loop fastener must be facing upwards.
If the MP7200 is mainly held with the left hand, it could make more sense to install it on the left-hand opening
of the handle (2b).
Information:
The belt is not permitted to be twisted here or during subsequent installation steps.
5. Pull the entire belt of the hand strap through until the welded end (1a of the figure in step 4) is stopped by
the opening on the handle.
6. Attaching the upholstery (optional). The hook-and-loop fastener must be facing upwards (1).
7. Tighten the handle with a screwdriver (torque: 0.8 - 1.0 Nm) at the top of the handheld control device.
