B&R MAPPC700A-ENG, Руководство пользователя

Страница: 345 / 524

Software • B&R Automation Device Interface (ADI) driver - Control Center
Ch
apte
r 4
Soft
w
are
345 Panel PC 700 with 945GME N270 CPU board User's Manual V 1.16
10.3 SDL Equalizer Einstellung
1) Start the Control Center in the Control Panel .
2) Then select the Display tab.
3) Click on Settings . This opens the following dialog box:
You can change the display's SDL equalizer settings in this dialog box. The equalizer is
integrated in the Automation Panel and adapts the DVI signal to various cable lengths. The
equalizer value is automatically calculated based on the cable length: You may set a different
equalizer value in order to obtain the best possible display quality (e.g. with low-quality cables or
poor DVI signal quality).
The value is optimally defined for the cable length when using the "Automatic setting".
The equalizer value can only be changed if the function is supported by Automation Panel 900
(starting with Panel Firmware version 1.04 or higher).
Figure 188: ADI Control Center - SDL equalizer settings