Technical data • Individual components
58
Automation PC 510 User's Manual V 1.01
Switch for
Terminating resistor
Abschlusswiderstand LED
Image 12: Serial interface (COM) terminating resistor
USB ports (USB3, 4)
The APC510 I/O board features a USB 2.0 (Universal Serial Bus) host controller with multiple USB ports, two of
which are accessible externally for easy user access.
Warning!
Peripheral USB devices can be connected to the USB interfaces. Due to the vast number of USB devices
available on the market, B&R cannot guarantee their performance. B&R does ensure the performance
of all USB devices that they provide.
Caution!
Because this interface is designed according to general PC specifications, extreme care should be
exercised with regard to EMC, cable routing, etc.
USB3, USB4
Universal Serial Bus (USB3, USB4)
1)
Type
USB 2.0
Design
Type A
Transfer rate
Low speed (1.5 Mbit/s), full speed
(12 Mbit/s), high speed (480 Mbit/s)
Current load
2)
USB3, USB4
Max. 0.5 A
Cable length
Max. 5 m (without hub)
2x USB Type A, female
USB4
USB3
Table 69: USB3, USB4 connection
1)
The interfaces, etc. available on the device or module have been numbered as such for easy identification. This numbering can differ from that used by
the particular operating system.
2)
Each USB port is secured with a maintenance-free "USB current-limiting circuit breaker" (max. 1 A).
MIC, Line IN, Line OUT
MIC, Line IN, Line OUT
Controller
Realtek ALC 662
MIC
Connection of a mono microphone with a 3.5 mm jack.
Line IN
Stereo Line IN signal supplied via a 3.5 mm jack.
Line OUT
Connection of a stereo sound de-
vice (e.g. amplifier) via a 3.5 mm jack.
3.5 mm socket, female
Line OUT
Line IN
MIC
Table 70: MIC, Line IN, Line OUT
A special driver is required in order to operate the audio controller. Drivers for approved operating systems are
available in the Downloads area of the B&R website (
).
Information:
Required drivers can only be downloaded from the B&R homepage, not from manufacturers' pages.
