International and national certifications
194
Automation Panel 5000 User's manual V2.11
10.3 Notes for the manual pursuant to radio approval
B&R products meet the EMC requirements for operation in the USA and Canada and comply with FCC and IC
regulations. Below are the corresponding "Radio Frequency Interference Statements" for the USA and Canada:
RF exposure statement
Complies with FCC and IC certifications
CE
conformity
Additional to the Low voltage and EMC directive the complete end-device must
be conform to the radio equipment directive.
FCC and IC
B&R products satisfy EMC requirements for operation in the USA and Canada
and are compliant with FCC and IC regulations. This has to be verified with every
device in which this B&R wireless board "RFM-2-NF and RFM-3-BTW" should
be installed. Corresponding "Radio Frequency Interference Statements" for the
USA and Canada:
USA:
Federal Communications
Commission (FCC)
This device complies with Part 15 of the FCC rules. Operation is subjected to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found comply with the limits of Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a commercial
environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. Operation of this equip-
ment in a resident area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Canada:
Industry Canada (IC)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux condi-
tions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisa-
teur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélec-
trique subi, même si le brouillage est susceptible d'en compromettre le fonction-
nement.
Mexico:
Instituto Federal de Teleco-
municaciones (IFETEL)
La operación de este equipo está sujeta a las siguientes dos condiciones: (1)
es posible que este equipo o dispositivo no cause interferencia perjudicial y (2)
este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que
pueda causar su operación no deseada.
Taiwan:
根據
NCC
低功率電波輻射性
電機管理辦法
規定:
第十二條:
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者
均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
第十四條:
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有
干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。
前項合法通信，
指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、
科學及醫療用電波輻射性電機設備之干擾。
此模組於取得認證後將依規定於模組本體標示審驗合格標籤，並要求平台廠商
於平台上標示『內含發射器模組:
RFM-2-NF
RFM-3-BTW
