Installation and wiring
Automation Panel 5000 User's manual V2.11
145
2. Feed the necessary cables through the swing arm shaft. The type of cables that must be used depends on
the type of connection. For more information, see section
"Connection options" on page 21
.
Swing arm shaft
Compression ring
Rotary swivel (with catch)
3. Connect the Automation Panel to the swing arm system. The rings must be installed in such a way that the
ring catch of the rotary swivel points forward towards the panel. The Automation Panel has been installed
correctly if the upper ring is flush with the flange. Fasten the assembly to the swing arm shaft using the 3 M6
headless screws (hex recess, size 3) with a tightening torque of 5 Nm.
Installation on a swing arm system is possible from the top or bottom depending on how the mounting unit is
installed on the panel and the resulting position of the flange output.
Caution!
After the angle of rotation has been set, the locking lever must be locked into position (approx.
5 Nm).
The screw in the locking lever is not permitted to be tightened. Fixing must be carried out exclu-
sively with the locking lever.
3x M6 headless screws
Locking lever
! 5 Nm