B&R 8I84T200037.01P-1, Руководство пользователя

Страница: 310 / 405

Programming guidelines
310 ACOPOSinverter P84 User's Manual 2.10
[MODBUS HMI] (Md2-), [MODBUS NETWORK] (MdI-) and [CANopen] (CnO-)
Code Name/Description Factory settings
Md2- [MODBUS HMI]
Communication with the graphic display terminal.
tbr2 [Baud rate HMI] 19.2 kbit/s
9.6 or 19.2 kbit/s on the integrated display terminal.
9600 or 19200 baud on the graphic display terminal.
The graphic display terminal only works if [Baud rate HMI] (tbr2) = 19200 Baud (19.2 kbit/s).
To take changes in the assignment of [Baud rate HMI] (tbr2) into account, you must:
• When using the graphic display terminal, confirm the changes in a confirmation window
•
When using the integrated display terminal, press the ENT key for 2 seconds
tFO2 [Format HMI] 8E1
Read-only parameter, cannot be modified.
Md1-
[MODBUS NETWORK]
Not applicable
CnO-
[CANopen com.]
AdCO [CANopen address] OFF
OFF to 127
bdCO [CANopen bit rate] 125 kbit/s
50 - 125 - 250 - 500 kbit/s - 1 Mbit/s
ErCO [Error code]
Read-only parameter, cannot be modified.
[COMM CARD] and [FORCED LOCAL] (LCF-)
Code Name/Description Factory settings
-
[COMMUNICATION CARD]
You can find additional information in the documentation for the specific card.
LCF-
[Forced local]
FLO [Forced local] [No] (nO)
nO [No] (nO) : Function not active
LI1
[LI1]
(LI1) to
[LI6]
(LI6)
-
LI6 The on-site operation is active in state 1 of the input.
[FORCED LOCAL] (FLO) is forced to [No] (nO) if [Profil] (CHCF) = [I/O profile] (IO) .
FLOC [Forced local Ref.] [No] (nO)
nO [No] (nO) : Not assigned (control via the terminals with zero reference).
AI1 [AI1] (AI1) : Analog input
AI2
[AI2]
(AI2) : Analog input
LCC [HMI] (LCC) : Assignment of the reference and the control to the graphic display terminal.
PG Reference: [HMI Freq Ref.] (LFr)
Command: RUN/STOP FWD/REV buttons.
[Encoder] (PG) : Encoder input if encoder card has been inserted
If the reference is assigned to an analog input or [Encoder] (PG) , the command is automatically assigned to the terminals as well as the logic inputs
FLOt [Time-out forc. local] 10 s
0.1 to 30 s
This parameter can be activated if [FORCED LOCAL] (FLO) is not equal to [No] (nO) .
Time delay before communication monitoring is resumed on leaving forced local mode.