Technical data • Entire device
Chapter 2
Technical data
Power Panel 500 User's Manual V 1.00
41
2.4.12 Status LEDs
The status LEDs are located on the back of the system unit.
Status LEDs
LED
Color
Status
Meaning
Green
On
Supply voltage OK
Green
Blinking
The device has booted, the battery status
is "BAD" - for more information, see see "
Red
On
The system is in standby mode (S5: soft-
off mode or S4: hibernate mode -Sus-
pend-to-Disk)
Red
Blinking
The MTCX is running, the battery status
is "BAD" - for more information, see see "
Power
Red /
green
Blinking
Service function for MTCX upgrade: A
red/green blinking power LED indicates
a faulty or incomplete MTCX upgrade.
The MTCX runs using the firmware ver-
sion installed when delivered. This could
be caused by a power failure during an
MTCX upgrade. An MTCX upgrade must
be performed again.
CF
Yellow
On
Indicates IDE drive access (CF)
On
Indicates an active SDL connection on
the monitor / panel plug.
Link
Yellow
Blinking
An active SDL connection has been inter-
rupted by a loss of power in the display
unit.
On
Application running
Run
Green
Off
Application is not running
Power LED
CF LED
Link LED
Run LED
Table 18: Data - status LEDs
Содержание 5PP551.0573-00
