Accessories • Terminal block for the button/switch interface
234
Panel PC 2100 swing arm user's manual V1.12
2 Terminal block for the button/switch interface
2.1 0TB1210.3100
2.1.1 General information
This 2-row, 10-pin TB1210 terminal block is used to connect to the interfaces on various interface options.
2.1.2 Order data
Model number
Short description
Figure
Terminal blocks
0TB1210.3100
Connector 300 VDC - 10-pin female - Cage clamp terminal block
- Protected against vibration by the screw flange
Table 231: 0TB1210.3100 - Order data
2.1.3 Technical data
Model number
0TB1210.3100
General information
Certification
CE
Yes
UL
cULus E115267
Industrial control equipment
HazLoc
cULus HazLoc E180196
Industrial control equipment
for hazardous locations
Class I, Division 2, Groups ABCD, T4
1)
DNV GL
Temperature:
B
(0 - 55°C)
Humidity:
B
(up to 100%)
Vibration:
A
(0.7 g)
EMC:
B
(Bridge and open deck)
Terminal block
Note
Nominal values according to UL
Number of pins
10 (female)
Type of terminal block
PUSH IN cage clamp terminal block connector
Cable type
Only copper wires (no aluminum wires!)
Distance between contacts
3.5 mm
Connection cross section
AWG wire
26 to 16 AWG
Wire end sleeves with plastic covering
0.14 to 1 mm²
Solid wires
0.14 to 1.5 mm²
Fine strand wires
0.14 to 1.5 mm²
With wire end sleeves
0.14 to 1.5 mm²
Electrical characteristics
Nominal voltage
300 V
Nominal current
2)
10 A
Operating conditions
Degree of pollution in accordance with EN 61131
Pollution degree 2
Table 232: 0TB1210.3100 - Technical data
1)
Yes, although applies only if all components installed within the complete system have this certification and the complete system itself carries the corresponding
mark.
2)
The limit data for each I/O module must be taken into consideration.
