B&R Industries Provit 5000, Руководство пользователя

Страница: 322 / 400

Provit 5000 User’s Manual 321
Chapt
er
6
So
ftw
are
Software • BIOS Upgrade
The components must be selected with the spacebar. This selection is confirmed with OK and
then the procedure is started.
4.2 Upgrade without Monitor/Display
A BIOS upgrade can also be carried out, if there is no visualization device (display or monitor)
available. The messages are emitted acoustically by the PC speaker. The following coding is
used:
4.2.1 Status Messages During Upgrades
All status messages consist of a long tone followed by one or more short tones.
4.2.2 General Messages
Status Messages
Short Tones Meaning
1 Beginning of a file load
2 Beginning the algorithm upgrade
3 Beginning deletion of the FlashPROM
4 Beginning of writing the data in FlashPROM
5 Programming is ended
Table 182: Acoustic status messages
General Messages
Long Tone Short Tones Message Necessary User Action
3 0 /h option specified for the non existent VGA
4 4
The boot block write protect switch has not been set to
Write Enable
1)
1) After approx. 20 seconds the upgrade tool tries to write again on the boot block. If this is unsuccessful, its repeats this procedure.
Set the switch to Write Enable and press Enter to
continue (see the section "Boot Block Switch")
1
2)
2) This continuous tone is emitted until a reset is triggered.
-
Leave the diskette in the drive and press Reset. The
system is completely updated after the reset Press the Reset button and let the system upgrade
completely
Table 183: General acoustic messages