Technical data
Panel PC 2200 built-in devices User's manual V 1.05 Translation of the original documentation
49
2.2.5.9 LED status indicators
The LED status indicators are located between the power button and Ethernet 2 interface.
LED "RUN"
LED "Link"
LED "Disk" (CFast)
LED "Power"
The following intervals are used for the LED status indicators:
Width of box: 250 ms
Repeat interval: 500 ms. 2 boxes thus correspond to one interval.
LED
Color
Status
Explanation
LED indicator
On
Power supply OK
The device is started up; the battery state is "BAD".
Green
Blinking
Information:
For additional information,
On
The system is in standby mode (S5: soft-off mode or S4: hiber-
nation/suspend-to-disk mode).
Red
Blinking
The MTCX is running; the battery state is "BAD". The system is in
standby mode (S5: soft-off mode or S4: hibernation/suspend-to-
disk mode).
Faulty or incomplete BIOS, MTCX or I/O FPGA update, power
supply OK
Faulty or incomplete BIOS, MTCX or I/O FPGA update, pow-
er saving (standby) mode (S5: soft-off mode or S4: hiberna-
tion/suspend-to-disk mode)
Faulty or incomplete BIOS, MTCX or I/O FPGA update, battery
state BAD, power supply OK
Faulty or incomplete BIOS, MTCX or I/O FPGA update, battery
state BAD, power saving (standby) mode (S5: soft-off mode or
S4: hibernate/suspend-to-disk mode)
Power
Red-Green Blinking
Information:
An update must be performed again.
Disk
(CFast)
Yellow
On
Indicates CFast access.
On
Indicates an active SDL connection on the panel connector.
An active SDL connection was interrupted due to power loss of
the panel.
Link
Yellow
Blinking
Information:
Check the power supply or power connection of the
connected panel.
Green
Blinking
Automation Runtime is starting up.
Controlled by Automation Runtime (ARemb and ARwin).
Green
On
Application running
Controlled by Automation Runtime (ARemb and ARwin).
Red
On
Application in service mode
Controlled by Automation Runtime (ARemb and ARwin).
Run
Orange
Blinking
A license violation has occurred.
Table 48: LED status indicators - Data
