5
S
B
I M P LY
E T T E R !
B K
&
Rear Panel Summary
1
CAT5 Zone Video Outputs -
Six zones of video output allow distribution with up to 1080P resolution.
The CAT5 video outputs supply both the power for use with a B&K LB10W or LB20F CAT5 --> RCA external
conversion module and differential video drive for for up to 500 feet.
2 RCA Zone Video Outputs -
Six zones of video output, Red, Blue and Green RCAs allow component
video drive for up to 150 feet.
3 Buffered Video Source Outputs -
Buffered video outputs will pass video signals connected to the
source inputs 1-9. Unity gain amplified signals essentially eliminate signal degradation and allow easy
cascading of multiple units.
4 Common Video Source Inputs -
Up to 9 high definition component video sources may be distributed
throughout any of the six video zones. Composite video (CVBS) and S-Video (Y-C) are transcoded to
component video (Y, Pr, Pb)
5 Dedicated Video Source Inputs -
Each of the six video zones has one local high definition source.
Local source connections must be home run to the connections indicated by the letter of the zone, i.e. IN
A. Selectable auto switching is available for use with these inputs when linked to a CT Receiver.
6 Serial Communication Ports -
The HD6 is normally controlled via serial communication sent from
the linked CT Receiver.
CT RS-232 LINK - Connects to a CT Receiver RS-232 RJ-45 jack, use straight through cable.
RS-232 I/O - Standard serial in/out. Connect RS-232 controllers here.
ETHERNET - Future control applications and flash memory upgrades.
7 IR Input -
A single 3-pin Phoenix-style connector is provided for connecting an external IR ‘eye’ or
Keypad to the HD6. Allows control of the HD6 for simple stand-alone applications where IR is the only
source of real-time control. A 12VDC, 200mA power output is supplied.
HARDWARE DESCRIPTION
1
2
3
4
5
6
7
