B&D MPC3 & MPC4 Coding Instructions
Step 1: Erasing Factory Code
1. Press and hold the top two buttons at the same time (unlock and lock) on the
remote we have supplied you. The LED light will flash 3 times. Continue holding
both buttons.
2. While still holding LOCK, release the UNLOCK button and then press it 3 times.
The LED light will flash constantly to indicate that the factory code has successfully
been deleted.
3. Release all buttons.
4. Test: press a button on the remote. If the deletion of the factory code has been
successful, the LED should not work when you press any button.
Please note: during the deletion procedure, make sure to keep the “up” button
pressed the whole time.
Step 2: Copying the Code from an Existing Operational Remote
1. Place your new remote we have supplied, and your existing operational remote
back to back
2. Press and hold one button on your new duplicator remote you wish to operate
your door. The LED should flash 3 times quickly to indicate that your duplicator
remote is in the “learn-code” mode. Do not release this button.
