10
Power Drive & Roll-A-Pro
®
installation instructions
10. Setting the Travel Limits
10.1 Initial Preparation:
CAUTION: Limit setup is not available when
running on battery backup
S T E P T H R E E
S T E P O N E
When setting the Close limit, ensure the position
is when the door makes first contact with the
ground. Alternatively for the Open limit the
position should be at the height of the garage
opening.
S T E P T W O
Switch power on
tip
S E T T I N G L I M I T S
Remove controls cover
Press to close
If door opens
Press to change
direction
Press to move
door to midway
S T E P O N E
C L O S E L I M I T P O S I T I O N
S T E P T W O
HOLD
Press to close door
S T E P T H R E E
W A R N I N G ! In setting the close limit position,
do not force the door into the floor with
excessive force, as this can interfere with the
ease of operation of the manual release
mechanism.
If door overshoots
Press
Press to position
Press to set
RELEASE
When door near
close, single
presses inch door
CLOSE limit should be
when rubber strip touches
the ground
S T E P O N E
O P E N L I M I T P O S I T I O N
S T E P T W O
HOLD
W A R N I N G ! The door will automatically close.
open and close again after the next step.
Ensure that nothing is in the door’s path.
Press to close door
RELEASE
When door near
open, single
presses inch door
OPEN limit should be the
height of the garage
opening
S T E P T H R E E
If door overshoots
Press
Press to position
Press to set
