Cycle Programming Sequence
13
Drain B
3
INC
Aux 3
3
INC
Signal
3
INC
Aux 4
3
INC
Aux 5
3
INC
End Step
3
INC
Level
3
INC
Temp.
3
INC
Time
3
INC
WDT
3
INC
SAVE?
ON to open Auxiliary Drain, if
equipped. -- means drain is
closed.
Aux 3 Relay
ON to activate the buzzer.
-- means buzzer is off.
Aux 4 Relay
Flashes for 1 sec.
P
ick only one of the thr
ee!
ON ends the step based
on water level. Use Watch
Dog Timer.
ON ends the step based
on Temperature. Use Watch
Dog Timer. See Heat cycle
tutorial in Appendix A.
ON ends the step based
on time. Do not use Watch
Dog Timer.
Example Cycle Construction:
Step 1 (Fill Step)
Turn on hot, cold or both.
Turn on Agitation, and enter RPM.
Turn on Level and enter water level (see chart, pg 31)
Turn on WDT and enter a time (9m, 0s typically)
Press enter to store.
Step 2 (Chemical Dose Step)
Turn on Chemical output
Turn on Agitation, and enter RPM.
Turn on Time and enter a time (ex: 0m, 10s)
Press enter to store.
Step 3 (Top off - make sure we are still at level)
Turn on hot, cold or both.
Turn on Agitation, and enter RPM.
Turn on Level and enter water level (see chart, pg 31)
Turn on WDT and enter a time (9m, 0s typically)
Press enter to store.
Step 4 (Wash/Agitation Time)
Turn on Agitation, and enter RPM.
Turn on Time and enter a time (ex: 9m, 30s)
Press enter to store.
The FM7 Stock program list (with your machine, also
available on our website, www.bandctech.com) is of
great use when customizing and creating wash programs.
There are many built in cycles available for use or
modification in custom programs. Here some commonly
used cycles:
Spin9: Drain routine - used after each bath cycle, but
not prior to the final spin.
Spin1: Low speed extract, 30 seconds
Spin2: Medium speed extract, 5 minutes.
Spin3: High speed extract, 5 minutes.
Note: Intermediate spins are not recommended - if the
FM7 cannot achieve a good balance, the program will be
terminated.
Note: Modifying the stock spin routines can cause the
machine to not extract - proceed with caution.
OR
OR
Press ENTER to store.
ON turns on the Watch Dog Timer.
Enter minutes and seconds.
-- turns off the Watch Dog Timer.
Aux 5 Relay
To turn on a function, press Enter, to turn off a function press Reset. Press Enter to edit a numerical
value (RPM, Time, etc.). Note: Setting a function to zero DOES NOT disable that function.
