23
User Manual
IT8000 3/8” TIE
-LOK DATA TOOL
IT7000 1/4” TIE
-LOK DATA TOOL
ITC800 CONTROL SYSTEM
Document # P80080 Rev. C.3
© Copyright
BAND-IT-IDEX, Inc. 2024
All rights reserved
All rights reserved
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
MOUNTING AND FIXTURING
At a minimum BAND-IT recommends that the tool be connected to a tool balancer or connected to an
ergonomic lift assistance arm.
Tool Balancer
•
The tool needs to be located directly above the clamp location if using a balancer as shown below
(Figures 34 & 35).
•
The balancer must support the weight of approximately 10 lb.
•
The tool comes with a hanger loop to mount to a balancer.
•
For more complex installations there are three mounting holes on the side. See page 26 for more
information about controlling the tool in roll and yaw.
•
Note that the center of gravity is behind the hanger bracket. For best performance, the pivot point
should be located on the CG, not directly on the hanger bracket. (Fig 33)
Figure 35
Figure 34
[57.4]
Figure 33