SKU #BNC1032-001
MAD SHARK V2 2.4GHz ARTR BRUSHLESS Mini F1 SPEED BOAT
1) Mad Shark V2 Racing Boat
2) Transmitter
3) Spare Nylon Propeller
4) Deans Plug W/Heat Shrinking Tube
Mad Shark is designed for use in fresh water only.It is not designed for use in salt water!
Mad Shark is not intended for persons under 14 years of age, unless closely supervised by an adult.
This model is capable of over 45 KPH, Personal injury or property damage may result from misue of
this product, take care and enjoy your model responsibly.
3
6
Mad Shark V2 2.4GHz ARTR Brushless Mini F1 Speed Boat
8
7
5) Boat Stand
6) Water proof ballon for RX
7) Rubber Band
8) 2.5mm Allen Key (For pushrod tighten)
2.0mm Allen Key (for Grub Screws)
5
4
ATTENTION:
IMPORTANT
Before racing your model boat, carefully check silicone tube for guarantee good water cooling system;
Avoid water inlet on the bottom of hull become deformed, otherwise, water cooling system failure, this
may lead to ESC burned out and motor defected.
CONTENTS OF SET
ESC with low voltage hard cut off at 3.2V per cell, when driving your boat , as soon as you notice boat
stop, that means ESC low voltage cut off effective, you should immediately drive boat back to shore in
slow speed , recharge battery and race again. don’t keep racing boat when ESC low voltage cut off
effective, otherwise, you will allow battery over discharge, battery voltage will reach very low and
won’t be recharged again.
Caution for LiPo battery:
