baltur 17530020, Инструкция по установке, использованию и обслуживанию

Страница: 59 / 72

MAINTENANCE
Analyse combustion gases and check that the emission values are
correct at least once a year, in compliance with current law.
• Clean air dampers, the air pressure switch with pressure port and
the relevant pipe, if any.
• Check the electrode condition. Replace them, if necessary.
• Clean the photocell. Replace it, if necessary.
• Have the burner and the chimney cleaned by specialised personnel
(stove repairer); a clean burner is more efficient, lasts longer and
is quieter.
• Check that the fuel filter is clean. Replace it, if necessary.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from impurities
or deposits deriving from the installation environment and/or from
combustion.
• Be careful during the reassembly operations to exactly centre the
gas diffuser with respect to the electrodes, making sure that they
are not earthed, which would result in the locking of the burner.
If the combustion head needs to be cleaned, remove the components
following the procedure indicated below:
• Unscrew the four screws (6) and turn the burner around the pin
(10) in the hinge.
• After pulling out the ignition and ionisation cables (14) from the
terminals of the respective electrodes, unscrew completely the nut
(9) and tighten the screw (16), moving it forward inside the gas
delivery fitting (30) (figure 3), far enough to permit subsequent
dismantling of the mixing unit.
• With the same wrench turn the ball joint (8) in the direction indicated
by the arrow, unhooking the lever that moves the combustion head
forward.
6 0002934660a
fig. 1
10
23 / 34
0006081328_202202
ENGLISH