BACKLIT BAR
INSTALLATION GUIDE
© 2023, All rights reserved BaltLED, UAB. Specifications are subject to change without notice.
READ THE INSTRUCTIONS CAREFULLY BEFORE MOUNTING
CONNECTION SCHEME
* Distance between power supply and bars.
! Power loss less than 5%.
! Recommendations for optimal use of power supply.
1/
2
POWER SUPPLY LOAD RECOMMENDATIONS
1.
Clean the inside of the sign with surface cleaner
(e.g. ethanol) to make sure it is free of dirt.
Tools reguired.
Wires, wire strippers, drill, screwdriver,
screws, surface cleaner, wire connectors and end caps.
2.
Remove protective layer from the backside of the
bar and stick the bar into place.
4.
Connect the bars by connecting female connector
with male connector.
3.
For firm fixing, use screws to secure LED bars within
the lightbox. Depending on the mounting surface, set
proper torque to not damage bar mounting lungs.
5.
Cap all unused wires. First - cut the connector off,
then
–
cap the wires).
7.
Connect the white wire with red stripe (+) of the LED
bars to the positive wire (+) of the power supply. Connect
the white wire (-) to the negative wire (-) of power supply.
6.
Choose a 24 VDC power supply
*
. Before connecting
wires to the power supply:
Option 1.
Connect female
connector with additional male connector.
Option 2.
Cut
the female connector off, then
–
connect extension
cable using connectors (if needed cable extension).
8.
Finish by connecting AC power line to the input
wires of the power supply.
POWER SUPPLY
QUANTITY
2 m*
5 m*
10 m*
bars
mm
2
AWG
mm
2
AWG
mm
2
AWG
BPSP-40-24V.1
3
1.3
16
2.5
13
6
10
BPSP-60-24V.1
4
1.5
15
4
11
10
7
BPSP-100-24V.1
8
2
14
6
10
10
7
BPSP-150-24V.1
13
3.3
13
10
7
16
5
www.baltled.com
August 7, 2023
IP 20
!
10 pcs
- max number of LED bars in one chain when the power supplied from single end.
! String end voltage can’t be less than
23V, do not exceed specified bar string length
*Take in consideration the insolation class for the power supply and connectors outside the lightbox, depending on the place it will be stored.
!
20 pcs
- max number of LED bars in one chain when the power supplied from both ends (additional wiring is needed)
! String end voltage can’t be less than
23V, do not exceed specified bar string length
