Balluff SmartVision BAE PD-VS-014-05, Руководство пользователя

Страница: 13 / 49

13
www.balluff.com
BAE PD-VS-014-05
Work steps
1. Open the revision cover.
a. Loosen two screws (1) using a
crosstip screwdriver.
2. Remove the battery from the holder.
a. Press the latching catch (2) downwards
using your finger.
3. Insert the new battery.
a. In reverse order.
4. Close the cover.
5. Adjust the BIOS set-up settings.
Replace the dust filter
The dust filter can be replaced as needed.
ATTENTION
The dust filter replacement must not occur if the equipment is still running. Disconnect the
equipment from the mains voltage!
Work steps
1. Loosen the side cover (knurled screw).
2. Open the side cover.
3. Remove the dust filter.
4. Insert a new dust filter.
5. Close the side cover.
Disposal
This product is covered by WEEE Directive 2012/19/EU on waste electrical and electronic equipment.
Dispose of the product properly and not as a part of the regular waste stream. The regulation of the re-
spective country are to be observed. Information is provided by the national authorities.