Balluff MATRIX VISION BVS 3D-RV1, Сборка и руководство по эксплуатации

Страница: 55 / 64

5 Maintenance
Warning: The only parts removable by the customer are the lens caps, which can be unscrewed. The
customer does not need to open the 3D stereo camera’s housing to perform maintenance. Unauthorized
opening of the housing will void the warranty. For all maintenance operations other than adjusting focus
and aperture, the product must be switched off.
To handle the optical components, wearing gloves is strongly recommended. The lens cap can be removed
by unscrewing the barrel. Then focus and the aperture can be adjusted with manual settings of the C-mount
lens.
Warning: The lens cap needs to be in place during normal operation to meet EMC requirements.
5.1 Lens cleaning
Glass lenses with antireflective coating are used to reduce glare. Please take special care when cleaning
the lenses. To clean them, use a compressed air duster or soft lens-cleaning brush to remove dust or dirt
particles. To remove stubborn dirt, wipe 1-2 drops of a non-alcohol-based lens cleaning solution formulated
for coated lenses (such as the Uvex Clear family of products) in a gentle circular motion with a cleaning tissue.
Always apply the fluid to a tissue rather than the lens itself.
Warning:
In case the lens covers are removed, a calibration check is required.
5.2 Change of Working Range
In case a change of working range is desired, an adjustment of the focus as well as the depth range is
required. Please note the limitations in the measurement range in
Table 3.2 .
MATRIX VISION GmbH
Manual: BVS 3D-RV1
22 Rev: 1.0
Status: Nov 14, 2022