Balluff LD2-T048-03-S75, Руководство пользователя

Страница: 36 / 144

14 english
6
IO-Link interface (continued)
6.7 System commands
Index Subindex Parameters Data
format
Access Value
range
Comments
Hex Dec Hex Dec
0002 2 00 0 System
command
UINT8 Write only 0x82 Reset Reset to factory settings
0xE0 Teaching linearity
range
Stores the new linearity
range
0xE1 Slmin Store teach-in start position
0xE2 Slmax Store teach-in end position
0xEA Enable linearity
range
Enables Linear Teach-in
Mode
0xEB Inversion Inverts the sensor output
0xEE Reset linearity
range
Reset linearity range to
factory default settings
0xEF Clear Teach-in Clear running Teach-
in-process
0xA5 Reset
maintenance
Reset maintenance
Tab. 6-7: System commands
6.8 Teach-in of the measuring range
The start and end points of the curve (Slmin and Slmax)
can be defined by teaching in to indicate the gradient
progress and gradient value of the curve.
Teach-in process of the measuring range
Index Subindex Access Value
Hex Dec Hex Dec
1. Activate the measuring range settings. 0002 2 00 0 Write only 0xEA
2.
Move target to new Slmin.
3)
3. Temporarily saves the current position as Slmin. 0002 2 00 0 Write only 0xE1
4.
Move target to new Slmax.
3)
5. Temporarily save the current position as SImax. 0002 2 00 0 Write only 0xE2
6. Apply and activate values for the new measuring range Slmin/
Slmax.
0002 2 00 0 Write only 0xE0
3) Within the original linear range
If the target leaves the measuring range
during teaching, the error message
TEACH_STATE_ERROR is reported.
BIP LD2-T_ _ _-03-S75
Inductive Positioning System