Balluff Ethernet/IP BTL7-V50D Series, Руководство по настройке

Страница: 56 / 70

www.balluff.com 21 english
The output data is normally recognized by the program as
SINT, i.e. BYTE. C
hange
is therefore clicked on in the
Module Definition field. The required I/O format can be
selected by clicking on the field under Name . The data
type should be changed to DINT.
6
Start-up and operation on a Rockwell RSLogix controller (continued)
Five magnets should be used in our example. The I/O-
Assembly 8 x Position and Time is selected so that all
positions and time information are transmitted. Three of
the eight possible magnets are not evaluated.
6.3 Configuration of the BTL7-V50D-…
If the BTL has been added to the project, configurations
can be made in the Controller Tags table under <Device
name>.C. The meaning of the individual parameters is
explained in chapter 5.3
Parameterization using the
Config-Assembly on page 16.
Config-Assembly is active in the example ( Config_
assembly_parameter_recognition = 1 ). Five magnets are
parameterized ( Number_of_Magnets = 5) and the direction of
measurement is reversed (
Direction _Counting_Toggle
= 1).
BTL7-V50D-…
Configuration Manual