Balluff BVS HS-QB-SDR-MA-02-02, Руководство по эксплуатации

Страница: 252 / 296

252
BVS HS-Q Series
Standard Hand Held Barcode Reader
5
References
5.6.2 RF Address
Stamping
Source Radio
Address
Delimiter
Character This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
This feature only applies if "Source Radio Address Transmission" on
page 217 is enabled.
Follow these instructions to select the delimiter character:
1 Determine the desired character, then find its hexadecimal equivalent on the on page 294 on
the inside back cover. A setting of 00 specifies no delimiter character.
2 Go to page 218 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
3 Scan the barcode: SET SOURCE RADIO ADDRESS DELIMITER CHARACTER.
4 Scan the appropriate two digits from the keypad in Appendix 18, Use the barcodes in this
appendix to enter numbers as you would select digits/characters from a keypad. , that repre-
sent the hexadecimal characters which were determined in the steps above. You will hear a
two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode
to abort and not save the entry string. You can then start again at the begin-
ning.
5 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.
Source Radio
Address
Delimiter
Character
Setting
Examples
STEP ACTION EXAMPLES
1 Desired Setting
No delimiter
character
, (comma) - (dash) / (slash)
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SET SOURCE RADIO ADDRESS DELIMiTER CHARACTER
4
Scan Two Characters
From
Appendix 18, Use
the barcodes in this
appendix to enter
numbers as you would
select digits/characters
from a keypad.
‘0’ and ‘0’ ‘2’ and ‘C’ ‘2’ and ‘D’ ‘2’ AND ‘F’
5 Scan ENTER/EXIT PROGRAMMING MODE