Balluff BVS HS-Q Series, Руководство по эксплуатации

Страница: 264 / 296

264
BVS HS-Q Series
Standard Hand Held Barcode Reader
7
Appendix B: Standard Defaults
7 Appendix B: Standard Defaults
The most common configuration settings are listed in the “Default” column of the table below.
Page references are also provided for feature descriptions and programming barcodes for each
parameter. A column has also been provided for recording of your preferred default settings for
these same configurable features.
Standard
Defaults
Parameter Default Your Setting
Page
Number
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore on
page 32
Obey 32
USB Suspend Mode on page 32 Disable 32
RS-232 ONLY
Baud Rate on page 34 9600 34
Data Bits on page 35 8 Data Bits 35
Stop Bits on page 35 1 Stop Bit 35
Parity on page 36 None 36
Handshaking Control on page 36 RTS 36
RS-232/USB-COM
Intercharacter Delay on page 38 No Delay 38
Beep On ASCII BEL on page 38 Disable 38
Beep On Not on File on page 39 Enable 39
ACK NAK Options on page 39 Disable 39
ACK Character on page 40 ‘ACK’ 40
NAK Character on page 40 ‘NAK’ 40
ACK NAK Timeout Value on page 41 200 ms 41
ACK NAK Retry Count on page 42 3 Retries 42
ACK NAK Error Handling on page 42
Ignore Errors
Detected
42
Indicate Transmission Failure on page 43 Enable 43
Disable Character on page 43 ‘D’ 43
Enable Character on page 44 ‘E’ 44
USB-OEM
USB-OEM Device Usage on page 54 Handheld 54
USB Interface Options on page 54
Ignore Reader
Configuration Host
Commands
54