Balluff BVS HS-Q Series, Руководство по эксплуатации

Страница: 160 / 296

160
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
GS1 DataBar™ Expanded Set Length 1
This feature specifies one of the barcode lengths for GS1 DataBar™ Expanded Length Control on
page 159 . Length 1 is the minimum label length if in Variable Length: For variable length decod-
ing, a minimum and maximum length may be set. on page 231 Mode, or the first fixed length if in
Fixed Length: For fixed length decoding, two different lengths may be set. on page 231 Mode.
Length includes the barcode’s data characters only. The length can be set from 1 to 74 charac-
ters.
Table GS1 DataBar™ Expanded Length 1 Setting Examples provides some examples for setting
Length 1. See page 232 for detailed instructions on setting this feature.
GS1 DataBar™
Expanded
Length 1 Setting
Examples
STEP ACTION EXAMPLES
1 Desired Setting 01 Character 07 Characters 52 Characters 74 Characters
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT GS1 DataBar™ EXPANDED LENGTH 1SETTING
4
Scan Two Characters
From
Appendix 18, Use
the barcodes in this
appendix to enter
numbers as you would
select digits/characters
from a keypad.
‘0’ and ‘1’ ‘0’ and ‘7’ ‘5’ and ‘2’ ‘7’ AND ‘4’
5 Scan ENTER/EXIT PROGRAMMING MODE
Select GS1 DataBar™ Expanded Set Length 1
Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CXBL1
~
DEFAULT
01 = Length 1 is 1 Character