Balluff BVS HS-P Series, Руководство по эксплуатации

Страница: 218 / 314

218
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
3.11.5 RF Address
Stamping
These features allow configuration of source radio data inclusion.
Source Radio
Address
Transmission Enables/disables the ability of source radio address information to be transmitted to the host and,
if so, at what position with respect to the label data. See
page 270 in “References” for detailed
information and examples for setting this feature.
Source Radio
Address
Delimiter
Character This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
NOTE
When included as a prefix, the source-radio ID is displayed after all label for-
matting has been applied. The 6 byte hex address is sent as 12 ascii charac-
ters, i.e., an address of 00 06 66 00 1A ED will be sent as (shown in hex): 30
30 30 36 36 36 30 30 31 41 45 44
Source Radio Address Transmission = Do
Not Include
Source Radio Address Transmission = Prefix
DEFAULT
$CBTAS00(CR
$CBTAS01(CR
NOTE
This feature only applies if "Source Radio Address Transmission" on page 218
is enabled.
Set Source Radio Address Delimiter Charac-
ter
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix D: Keypad
representing your
desired character(s). End by reading the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CBTAD
~
DEFAULT
00 = No Delimiter Character