Balluff BTL7-T500 Series, Руководство по настройке

Страница: 71 / 82

30 english
4
Configuration (continued)
4.11.5 Parameters for addressing
Parameter 918 can be used under certain conditions to set
the address and read out the set address. This depends
on whether the device has DIP switches, how they are set,
and whether the Set Slave Address service is being used.
For additional information see section 4.1 Addressing on
page 10.
4.11.6 2050 Temperature
In the five subindices the temperature of the sensor
electronics can be read out in °C. Note that the
temperature inside the sensor on the circuit board is
usually higher than the surroundings and is only updated in
intervals of about 6 minutes.
In subindices 1 to 4 the minimum and maximum
temperature of the current session (since the last reset or
power-on) and the minimum and maximum temperature
over the entire service life can be read.
4.11.7 Parameter for status display
Parameter 65001 indicates the current operating status
with errors and warnings.
BTL7-T500-…
Configuration Guide