Balluff BOS R254K-UUI-PR10-S4, Руководство пользователя

Страница: 28 / 74

12 english
The specifications are typical values for 24 V DC at room
temperature.
The sensor is fully operational immediately, with full
accuracy after warm-up.
Further data can be found at
www.balluff.com
on the product page.
9.1 General features
Light type Red light
Wave length 633 nm
Beam characteristic Divergent
Usage category DC13
LED group per IEC 62471 Exempt group
Reference units
Reference reflector
(for BOS R254K-…-PR10-…)
BOS R-1
Reference receiver (for
BOS R254K-…-RS10-…)
BOS R254K-UUI-
RE10-S4
Reference transmitter
(for BOS R254K-…-RE10-…)
BOS R254K-UUI-
RS10-S4
9.2 Ambient conditions
Ambient temperature −10...+70 °C
Storage temperature −10...+70 °C
Protection per IEC 60529 (when
threaded together)
IP67, IP69K
Ambient light ≤ 10 kLux
9.3 Detection range/Measuring range
Range S
n
BOS R254K-…-PR10-… ≤ 8 m
BOS R254K-…-RS10-… ≤ 20 m
BOS R254K-…-RE10-… ≤ 20 m
Range S Adjustable
Temperature drift (% of S
n
) ≤ 10%
Light spot size at 1 m
BOS R254K-…-PR10-… ≤ 60 × 60 mm
BOS R254K-…-RS10-… ≤ 30 × 30 mm
BOS R254K-…-RE10-… ≤ 60 × 60 mm
Light spot size at 5 m
BOS R254K-…-RS10-… ≤ 110 × 110 mm
9.4 Electrical data
Operating voltage
SIO 10...30 V DC
IO-Link 18...30 V DC
Rated operating voltage U
e
24 V DC
Rated operating current I
e
100 mA
No-load current I
0
at U
e
≤ 20 mA
Rate insulation voltage U
i
75 V DC
Readiness delay t
v
300 ms
Load capacity at U
e
≤ 100 nF
Residual current I
r
≤ 500 μA
Residual ripple (% of U
e
) ≤ 10%
Switching frequency
Standard mode
Speed mode
1 kHz
2 kHz
Protection class II
Voltage drop U
d
at I
e
≤ 2.5 V
Short circuit protection yes
Protection against miswiring yes
Polarity reversal protected yes
9.5 Electrical connection
Connection Plug M12x1
Number of pins 4
9.6 Output / Interface
Output pin 4 (switching) Switching output/IO-Link
Switching output pin 4 push-pull
Input/output pin 2 (switching) Switching output/current
analog output/digital
input
Switching output pin 2
(switching)
PNP/NPN/push-pull
Analog output pin 2 4…20 mA
Switching function (switching) NO contact/NC contact
(NO/NC)
Interface IO-Link
Version 1.1
Baud rate COM3 (230.4 kBaud)
9
Technical data
BOS R254K-UUI-PR/RS/RE10-S4
Photoelectric Sensors