Balluff Network Interface / IO-Link
www.balluff.com
5
2
Safety
Intended use
The BNI IOL-
… acts as a decentralized input/output sensor module, which is connected to a
higher-level IO-Link master module through an IO-Link interface.
Installation and
startup
Attention!
Installation and startup must only be carried out by trained technical personnel.
Qualified personnel are persons who are familiar with installation and operation
of the product and have the necessary qualifications for these tasks.
Any damage resulting from unauthorized tampering or improper use voids the
manufacturer's guarantee and warranty. The operator must ensure that
appropriate safety and accident prevention regulations are observed.
General safety
instructions
Commissioning and inspection
Before commissioning, carefully read the User's Guide.
The system must not be used in applications in which the safety of persons is dependent
upon proper functioning of the device.
Authorized personnel
Installation and startup must only be carried out by trained technical personnel.
Intended use
Warranty and liability claims against the manufacturer are rendered void by:
−
Unauthorized tampering
−
Improper use
−
Use, installation or handling contrary to the instructions provided in this User's
Guide.
Obligations of the operating company
This device meets the specifications for EMC, Category A. It may cause HF noise.
The owner/operator must take appropriate precautionary measures against this for its use.
The device may only be used with an approved power supply. Use only approved cables.
Malfunctions
In the event of defects and device malfunctions that cannot be rectified, the device must be
taken out of operation and protected against unauthorized use.
Intended use is ensured only when the housing is fully installed.
Resistance to
aggressive
substances
Attention!
The BNI modules always have good chemical and oil resistance. When using an
aggressive medium (e.g. chemicals, oils, lubricants and coolants in high
concentration (such as with low water content)), the compatibility of the material
with the respective medium must first be tested. No warranty claims will be
honored for faults or damage to the BNI modules caused by the use of
aggressive media.
Dangerous
voltage
Attention!
Before maintenance, disconnect the device from the power supply.
Note
In the interests of product improvement, Balluff GmbH reserves the right to
change the technical data of the product and the content of this manual at any
time without notice.
