Balluff BMP 01-ZLZPP 1A 00-P S75 Series, Руководство пользователя

Страница: 42 / 292

8 english
3
Structure and function (continued)
3.2.1 Switching output
– Adjustable switch-on and switch-off point
– Measuring range display is a factory setting (active over
the entire measuring range)
– Normally open/normally closed (switchable)
The switching output is described in Chapter 6 on
page 15.
3.2.2 IO-Link interface
– Absolute measured value (μm)
– Measuring range display via status bit
– Four switching signals
– Extensive configuration options for the measured value
and switching signals
– Functions for state monitoring:
– Temperature detection
– Operating hours counter
– Boot cycle counter
The IO-Link interface is described in section 7 on
page 17.
3.3 LED display
In normal operation, three LEDs indicate the operating
state of the BMP.
Fig. 3-2:
Green Yellow Red
Positions of the LEDs
LED Operating state
Color State
Green on Power OK
Inverse
flashing
IO-Link communication active
Yellow off The target is located within the
configured measuring range.
on The target is located outside of the
configured measuring range.
Flashing
5 Hz
The excess gain of the
measurement is low.
The measured magnetic field
strength of the target is small.
Red off No error
Tab. 3-1: LED display
Note, tip
Sustained, asynchronous flashing of all LEDs
indicates a serious error. The BMP likely needs
to be replaced.
BMP 01-ZLZPP _ 1A- _ _ _ _ -00 -P _ _ /P _ _ -S4/P _ _ -S75
Magnetic Field Positioning System