Balluff BDG D 60-H020-NUS01-1318-0000-S4L4 Series, Руководство пользователя, Страница: 35 / 94

www.balluff.com 15 english
8.1 Troubleshooting
Error Possible causes Troubleshooting/explanation
The controller does not receive any
position information.
The required operating voltage is not
available.
No IO-Link process data is transferred
in battery mode.
►
Check if there is any voltage and
that the BDG is correctly
connected.
The sensor is not properly connected.
►
Check pin assignment and correct
if necessary.
Display or LED does not light up. The required operating voltage is not
available.
An external power supply is required for
the display unit to function.
►
Check if there is any voltage and
that the BDG is correctly
connected.
The display is switched off via IO-Link
parameterization.
►
Change the Power Display Mode
parameter (see configuration guide).
The numerical display does not show
any position information.
The BDG version does not have a
numerical display
Check design according to type code
Tab. 8-1: Troubleshooting
8.2 Repair
Repairs to the product may only be performed by Balluff.
If the product is defective, contact our Service Center.
8.3 Disassembly
Disassembly is performed in reverse order to assembly.
1.
Loosen set screws.
2.
Remove sensor from shaft.
NOTICE
Damage to the machine
If the cylindrical pin falls into the machine during removal
and remains there, this can cause damage to the
machine.
►
Before switching on the equipment or the machine
part again, make sure that the cylindrical pin is
present and has not fallen into the equipment.
8.4 Disposal
►
Observe the national regulations for disposal.
Additional information can be found at
www.balluff.com
on the product page.
8
Malfunctions, repair, disassembly and disposal
BDG D_ _60-H020-NUS01-1318-0000-S4L4
Digital position indicator