Balluff BCS Q40BBAA-PIM20C-EP-GS04 Series, Руководство по настройке, Страница: 170 / 172

84 english
7.9 Parameter Manager
7.9.1 Description
The parameter manager is responsible for the saving of
parameters in the permanent memory of the device. On
startup, all stored parameters are read from permanent
memory; if parameters are changed, the data is stored
within the permanent memory by the parameter manager.
All data is protected with a CRC32 checksum. In the event
of damaged memory, the parameter manager outputs the
Parameters not consistent event.
If this error only affects parameters which can be restored,
the memory is repaired directly by the device. In this case
all set data is reset to the default settings and the device
signals this state via a warning.
Acknowledge warning
1. Check set data.
2. Acknowledge warning by sending the system
command 0xC1- Acknowledge User Parameters Reset
to the device.
Data can be very easily restored via the IO-Link parameter
server ( Data storage see page 7).
7.9.2 System Commands
Command Value Device Action
0xC1 (193) Acknowledge User Parameter
Reset
– Acknowledge message and
restore the correct device
parameters.
Tab. 7-32: Parameter Manager – System Commands
7.9.3 Events
Event Code Event Type Event – Description – Remedy Device Status
0x8D24 (36132) Warning Parameter write error – for information purposes
only.
0 – Device is operating properly.
0x8D25 (36133) Error Parameters not consistent – basic settings are
used, service required. Parameterization
processes and resets can no longer be
performed.
4 – Failure
0x8D26 (36134) Warning User data was reset to the default settings.
►
Check settings and acknowledge warning.
1 - Maintenance required
Tab. 7-33: Parameter manager – Events
7
System Functions (continued)
956947_AB ∙ EN ∙ G23; Subject to modification. Replaces E23.
BCS Q40BBAA-PIM20C-EP _ _ _ -GS04
Capacitive Proximity Switches