balfor SHARK Series, Техническое руководство, Страница: 37 / 59

Use and maintenance manual
Circular saw
SHARK
36
4 CONNECTIONS
4.1 CARDAN AND CONVEYOR BELT MODELS CONNECTIONS
4.1.1 Connection to the tractor’s three-point hitch

The tractor's three-point hitch must coincide or be adapted.

In the area of the arm tie-rods of the tractor's rear lift, there is a danger of injury due to crushing
and shearing points.

Do not use the external control to lift the machine.
ATTENTION!
Cardan models can only be used if they are connected to the tractor's three-
point hitch.

Move the tractor closer to the circular saw until the lift bars coincide
with the lift arm attachments (
1 and 2) of the machine and connect
them using the provided pins.

Insert and lock the safety plugs into the pin hole and make sure
they are locked.

Connect the third point to the upper hitch (
3) and adjust its length in
order to position the circular saw parallel to the ground.

Insert and lock the safety plugs. Lock the anti-loosening device of
the third point.
 Raise the machine a few centimetres off the ground and by acting
on the lateral tie-rods of the lift bars, block its lateral movement.