Section 1
Quick Start
MN715J
Quick Start 1-1
Overview
If you are an experienced user of Baldor controls, you are probably already
familiar with the keypad programming and keypad operation methods. If so,
this quick start guide has been prepared for you. This procedure will help get
your system up and running in the keypad mode quickly and will allow motor
and control operation to be verified. It assumes that the Control and Motor
are correctly installed (see Section 3 for procedures) and that you have an
understanding of the keypad programming & operation. It is not necessary to
wire the terminal strip to operate in the Keypad mode (Section 3 describes
how to wire the terminal strip).
The quick start procedure is as follows:
1.
Read the Safety Notice and Precautions in section 2 of this manual.
2.
Mount the control. Refer to Section 3, “Physical Installation” procedure.
3.
Connect AC power. Refer to Section 3, “AC Line Connections”.
4.
Connect the motor. Refer to Section 3, “AC Line Connections”.
Quick Start Checklist
Check of electrical items.
1.
Verify that the AC line voltage at the source matches the control rating.
2.
Inspect all power connections for accuracy, workmanship and tightness
as well as compliance to codes.
3.
Verify that the control and motor are grounded to each other and the
control is connected to earth ground.
4.
Check all signal wiring for accuracy.
5.
Be certain all brake coils, contactors and relay coils have noise
suppression. This should be an R-C filter for AC coils and reverse
polarity diodes for DC coils. MOV type transient suppression is not
adequate.
Check of Motors and Couplings
1.
Verify freedom of motion of motor shaft.
2.
Verify that all motor couplings are tight without backlash.
3.
If holding brakes are used, verify they are properly adjusted to fully
release and set to the desired torque value.
Содержание ID15J1F50-ER
