Baldor ID15J1F50-ER, Инструкция по установке и эксплуатации

Страница: 39 / 89

4-2 Programming and Operation MN715J
SHIFT
Press SHIFT in the program mode to control cursor movement. Pressing the
SHIFT key once moves the blinking cursor one character position to the right.
While in program mode, a parameter value may be reset to the factory preset
value by pressing the SHIFT key until the arrow symbols at the far left of the
keypad display are flashing, then press an arrow key.
RESET
Press RESET to clear all fault messages (in local mode). This key can also
be used to return to the top of the block programming menu without saving
any parameter value changes.
PROG
Press PROG to enter the program mode to check or to edit a parameter
value.
Y - (UP Arrow).
Press Y to change the value of the parameter being displayed. Pressing Y
increments the value to the next greater value. Also, when the fault log or
parameter list is displayed, the
Y
key will scroll upward through the list. In the
local mode pressing the
Y
key will increase motor speed to the next greater
value.
ENTER
Press ENTER to save parameter value changes and move back to the
previous level in the programming menu. In the display mode the ENTER key
is used to directly set the Local Speed Reference.
B - (Down Arrow)
Press
B
to change the value of the parameter being displayed. Pressing
B
decrements the value to the next lesser value. Also, when the fault log or
parameter list is displayed, the
B
key will scroll downward through the list. In
the local mode pressing the
B
key will decrease motor speed to the next
lesser value.