BALCO AU160131, Руководство пользователя, Страница: 8 / 21

AFTER SALES SUPPORT
800-372-5715 USA
MODEL: AU160131 PRODUCT CODE: 11215 10/2019
customercare@balcolifestyle.com
AFTER SALES SUPPORT
800-372-5715 USA
MODEL: AU160131 PRODUCT CODE: 11215 10/2019
customercare@balcolifestyle.com
14 13
How to read indicator light of the battery clamp
Indicator Light Meaning
The red and green indicator lights
flash alternately
1. Standby
2. Ready to start after you have
correctly connected the polarity of
the clamps to the corresponding
battery terminals. Red clamp to the
positive terminal. Black clamp to the
negative terminal
The red indicator light stays on
Battery clamps have not been
connected correctly or have short-
circuited
The red indicator light flashes rapidly The over-temperature protection
has been triggered. This is usually
because the temperature of the clamp
exceeds 149 o F / 65 (+/-5) o C. The output
is automatically shut off and the red
indicator light starts flashing rapidly
(5 times per sec).
When the temperature drops lower
than 140
o
F / 60 (+/-5)
o
C, the red
and green indicator lights will flash
alternately (3 times per sec).
The green light flashes slowly The voltage of the product is too low.
You need to charge the Jump Start
Power Bank
Please note:
1. Use the original smart battery clamp to start the car
2. Do not use this unit if any cable clamp or cord is damaged
3. Never connect two clamps together. Do not connect both cable clamps to
the same piece of metal. This may damage the Jump Start Power Bank and
void warranty
Operation instructions Operation instructions
2. Start your car. With the LED flashing alternately red and green, turn the key or
press your ignition to start the car
• If you failed to start your car, you need to disconnect the battery clamps from
the battery. Remove the black clamp first and then remove the red clamp.
Once this has been done, remove the socket plug from the Jump Start Power
Bank. Wait for at least 30 seconds, then try steps 1 and 2 again ensuring the red
and black clamps do not touch each other once connected
• If you failed to start your car after 3 attempts, you can use the force start
function. See step 3
3. Once your car has started, remove the battery clamps from the car battery within
30 seconds
a. Please note: remove the black clamp first and then remove the red clamp. Once
this has been done, remove the socket plug from the Jump Start Power Bank
b. Optional: force start function. First, please make sure that the clamps are
connected to the correct polarity battery terminal.
• The Red clamp connected to the positive terminal (+) and the Black clamp
connected to the negative terminal (-)
• Hold the force start button down for 3 seconds. When the indicator light of the
smart clamp is solid green, you will have 30 seconds to start the vehicle
3